How to reduce supply chain overheads

List of the catalog of this article:

• 1, How to divide the position of Kaiyue engine into 1 cylinder, 2 cylinder, 3 cylinder and 4 cylinders, and how to change the cylinder line.
• 2, How much displacement the 2014 manual transmission Buick?
• 3, What engine does Buick New Kaiyue use
• 4  
  、How about the Buick Kaiyue hrv engine
• 5,How to reduce supply chain overheads How many cylinders the old Buick Cavaque
• 6 、Buick Kaiyue engine compartment structure

How to divide the position of Kaiyue engine into 1 cylinder, 2 cylinder, 3 cylinder and 4 cylinders, and how to change the cylinder line.

1. How to change the cylinder wire: Prepare a hexagon wrench before changing the cylinder wire. Stop the car, tighten the handbrake, pull out the car key, and disconnect the negative pole of the battery. Remove the hood with a hex wrench. After removing the engine hood, the engine oil filling cover must be covered to prevent things from falling into it.

2. The Kaiyue engine is divided into 1 cylinder, 2 cylinders, 3 cylinders and 4 cylinders: from left to right, 1423. An ignition coil with 14 cylinders and an ignition coil tube with 23 cylinders.

3. The order of the 6-cylinder line of Buick Kaiyue is: 5 on the right after going, and 6 on the left after going. Buick Kaiyue is positioned as an entry-level family car, with a dynamic appearance and textured interior, bringing the quality enjoyment of "the first car in life".

How much displacement the 2014 manual transmission Buick?

model (the 2013 model and 2015 model without the 2014 model) manual transmission Buick Kaiyue model engine displacement is a 5L naturally aspirated engine. The 2013 model and 2015 Kaiyue manual transmission only has this displacement model. You can refer to and verify it by looking at the picture below.

If there is no 2014 model, the engine displacement of the 2013 and 2015 manual transmission Buick Kaiyue models is a 15L naturally aspirated engine. The 2013 and 2015 Kaiyue manual transmission has only this displacement model. You can refer to and verify it by looking at the following picture.

How much is the new Buick Kaiyue 2014 manual self-shield 5 displacement? 2013 5L manual classic 690,000 yuan, 2013 5L automatic classic 190,000 yuan.The spread-wing headlight and the grille are dived into the corner, and the shape is dynamic.

What engine does Buick New Kaiyue use

1. Buick New Kaiyue adopts DOHC 16V TwinTec engine Xinkaiyue's DOHC 16V TwinTec engine The new calibration is quiet and smooth, and meets the Euro IV emission standard. With the newly adjusted chassis, it is calm in the surging, and it is difficult to hide the passion in the solid. In addition, under the premise that the power output is not affected in any way, more.

2. The whole series of the new Buick Kaiyue uses a 3-liter naturally aspirated three-cylinder engine. The 3-liter naturally aspirated engine of Buick Caque has a maximum torque of 107 horsepower and 133 Nm. This oneThe motive can output the maximum power at 6200 rpm and the maximum torque at 4000 rpm.

3. Buick New Kaiyue adopts DOHC 16V Twin-Tec engine.

How about the Buick Kaiyue hrv engine

1. The reliability of the Kaiyue engine is also very good. It adopts a new generation of technology independently developed by JAC Automobile, which can reduce the failure rate and improve reliability. In addition, its protective performance is also very strong, which helps to reduce the possibility of car damage.

2. In addition, Buick Conve also has intelligent driving technologies such as adaptive driving and engine on/off in terms of power system. Comfort and technologyConfiguration The interior design of Buick Kaiyue and HRV is relatively simple. They are both two-row seat models with similar space size.

3. As a naturally aspirated engine with a 3-liter displacement, its power performance is average and it is only suitable for urban use. This type of engine is generally only suitable for home use. It has high fuel economy, low failure rate, and relatively low cost of later repair and maintenance.

4. This engine has been specially adjusted to be fully suitable for domestic No. 93 gasoline, and it also meets stricter Euro III emission standards in terms of environmental protection.

5. The 3-liter naturally aspirated engine of Buick Regue has a maximum torque of 107 horsepower and 133 Nm. This engine can output maximum power at 6,200 rpm and maximum torque at 4000 rpm.This engine is equipped with multi-point electric injection technology and uses aluminum alloy cylinder head and cylinder block.

6. In a word, the engine quality performance of Buick Lover in 2015 is commendable. It not only has advanced technical applications, but also shows high reliability and stability in long-term use. For consumers who seek a high-quality driving experience, this model is definitely a good choice.

How many cylinders is the old Buick Kaiyue

The engine used by the old Buick Kaiyue is a four-cylinder engine, and the reliability and durability of the old Buick Kaiyue engine are relatively good. The old Buick Cauque has a 5-liter naturally aspirated engine and a 6-liter naturally aspirated engine. The maximum torque of Kaiyue's 5-liter naturally aspirated engine is 113 horsepower and 141 Nm.

The engine used by the old Buick Clago is a four-cylinder engine, and the reliability and durability of the old Buick Calago engine are relatively good. The old Buick Cauque has a 5-liter naturally aspirated engine and a 6-liter naturally aspirated engine. Kaiyue's 5-liter naturally aspirated engine has a maximum torque of 113 horsepower, 141 Nm.

The engine used by the old Buick Kaiyue is a four-cylinder engine. The reliability and durability of the old Buick Kaiyue engine are relatively good. The old Buick Kaiyue has a 15-liter naturally aspirated engine and a 16-liter naturally aspirated engine. The 15-liter naturally aspirated engine of Kaiyue has a maximum torque of 113 horsepower, 14 1 cow·meter is the largest engine.

Buick Kaiyue engine compartment structure

1. Kaiyue is based on General Motors global platform.Its shape comes from the Italian pininfarina, one of the world's three major automobile design companies, with a 73-year design history. The structure of the engine compartment of Buick Kaiyue is: air filter; steering oil pot; brake oil pot; oil filling port; battery; oil meter; glass kettle; antifreeze rehydration.

2. The engine compartment of the Kaiyue model: The engine compartment of Buick Kaiyue is arranged very reasonably and neatly. There is a large buffer space between the engine and the water tank. In addition to enabling the engine to better dissipate heat and extend its service life, this design can also play a role as a safety buffer in the event of a frontal collision of the vehicle.

3. The vast majority of the hoods of cars have an opening handle at the bottom of the dashboard of the driver's left calf towards the front of the car, and the hood will bounce after pulling.Start about 1cm, then lift the cover with one hand, and reach in from the middle net with the other hand to find the wrench to open the cover. The positions of each model are basically similar, but the direction of action may be different.

4. In terms of power system, the new Kaiyue is still equipped with two engines with 6-liter and 8-liter displacement equipped with the old model.

5. When you need to check, overhaul or add oil and other maintenance work on the Buick Rever, it is necessary to open the front cover. Once the front cover is opened, you can easily access various parts in the engine compartment. After finishing the work, please remember to gently lower the front cover and make sure it is completely locked in place to ensure driving safety.

6. See the picture, first open the engine compartment switch, the hatch automatically pops up a seam, and then put your finger into the middle position in front of the hatch.In the gap, you will touch the latch switch up, lift the switch up to open the lock, and lift the hatch with the other hand.